Thermo Scientific DCS4 Manual page 54

Using the ACW for Task Transfer
Entering Primary ID
The Worker enters
their Primary ID
according to the
System Setup (see
Notes regarding
Worker ID Input).
The System
Administrator sets the
Hide PIN in the
Configuration
program (see A Guide
to Using DCS4 ACW
Manager Ref No.
EPD/MHB/61064/000)
.
EPD Error Messages
6-4 A Guide to Using DCS4 Access Control Workstation
The Worker identifies themselves be entering their Primary ID
(see Notes regarding Worker Prompt Types (page
If the Primary ID is entered through the keypad, the following
screen will appear echoing the characters as they are typed in:
Note: The System Administrator can disable the keypad entry
of the Primary ID. See A Guide to Using DCS4 System
Administrator Ref No. EPD/MHB/61065/000 for more
information.
Note that the picture above displays the Worker's Primary ID.
If the Hide PIN is selected, the Worker's Primary ID is
displayed as follows:
If any of the Dose or DoseRate Alarm thresholds been
exceeded during the previous task, the system shall deny
transfer and ask the Worker to exit immediately, as follows:
Issue: 1.78
4-7)).
Thermo Fisher Scientific