Note Regarding The Display Of Worker Details At The Acw - Thermo Scientific DCS4 Manual

Using the ACW for Task Transfer
Note regarding the display
of Worker details at the
ACW
Selecting the Transfer
Process
6-2 A Guide to Using DCS4 Access Control Workstation
If the Same Task for Escort/Escortee option is enabled
in the System Setup, it is not possible to Transfer onto a
new Task for the Escort or escorted Worker.
6. Entering the new Task Details – see
Task (page 6-8)
7. If the Confirm Task Accept option is enable in the
System Setup (see A Guide to Using DCS4 Data
Management and Reporting Ref No.
EPD/MHB/61066/000), the Worker Briefed message is
displayed – see
8. If a Mailbox message has been created for the selected
task, the message is displayed – see
(page 6-9).
9. If enabled, the Dose Profile is collected from the EPD -
see Reading Dose Profile (page
10. The EPD is cleared and re-issued – see
Re-issuing the EPD (page
If Display Forename1 instead of Initials at ACW is ticked on
the System Configuration tab of the System Setup screen, the
Worker's name will be displayed as follows:
If Display Forename1 instead of Initials at ACW is NOT ticked
on the System Configuration tab of the System Setup screen,
the Worker's name will be displayed as follows:
Throughout this manual, the Initials option has been set.
See A Guide to Using DCS4 Data Management and Reporting
Ref No. EPD/MHB/61066/000 for further information.
Select the Transfer Process from the menu using the Up/Down
buttons and 'ENT'.
Identifying the new
Has Worker been Briefed (page
Mailbox Message
6-10).
6-11).
Issue: 1.78
6-9).
Clearing and
Thermo Fisher Scientific