Dialog Text; Notes For The Operator; Listing Of Dialog Texts - Siemens Sinumerik 840C Diagnostics Manual

04/96
1.6

Dialog text

1.6.1

Notes for the operator

With many operator inputs, texts are displayed in the left two thirds of the input
line for support and for error diagnostics.
Ç Ç Ç Ç Ç Ç Ç Ç Ç Ç Ç Ç Ç Ç Ç Ç
Ç Ç Ç Ç Ç Ç Ç Ç Ç Ç Ç Ç Ç Ç Ç Ç
1.6.2

Listing of dialog texts

All notes for the operator are listed in the following table in alphabetical order.
BLOCK NOT AVAILABLE
BLOCK NUMBER TOO
LARGE
BLOCK STRUCTURE
WRONG
BLOCK TOO LONG
CHARACTER NOT
ALLOWED
CHARACTER NOT
AVAILABLE
COMMENTS ERROR
CYCLE DISABLE
CYCLE IN THE EPROM
DATA TRANSMISSION
RUNNING

Siemens AG 2001 All rights reserved 6FC5198–jAB40
SINUMERIK 840C / SIMODRIVE 611–D (DA)
Area for notes for the operator
Dialog text Appears with the
following event
When searching for blocks
in the part program
Generating block number
With "Correction block"
function
When editing part
programs, a block must
not be longer than 120
characters
Taking over an input value
(e.g. with the input key)
When searching for
characters in part
programs
Occurs when editing if the
brackets do not match up
When handling cycles
(editing, copying, etc.)
Information while handling
cycles
Editing part programs
1 Alarms
1.6 Dialog text
Input line
What must be done
or
What is wrong
––
Block number cannot be
greater than N9999
Cursor is at the start of the
wrong block
Conclude block with "LF"
Input value has the wrong
format
––
Check the number of
brackets set
Remove "Cycle disable"
interface signal
––
Stop interface
1–223