Siemens Sinumerik 840C Diagnostics Manual page 103

04/96
09/01
100400 V.24 transfer initiated
Scan
On initiation of V.24 transfer
Effect
None
Explanation
Initiation of the V.24 transfer is indicated by the issue of this alarm.
Remedy
Acknowledge alarm
Remark
Alarm 100400 is no longer issued from SW 4.4 and 5.1.
Note
Alarm from SW 6.3, not available any more from SW 4.4
100401 V.24 transfer completed
Scan
On completion of the V.24 transfer
Effect
None
Explanation
Completion of the V.24 transfer is indicated by the issue of this alarm.
Remedy
Acknowledge alarm
Remark
Alarm 100401 is no longer issued from SW 4.4 and 5.1
Note
Alarm from SW 6.3, not available any more from SW 4.4
100402 V.24 data output active %0 %1
Scan
Serial communication via V.24
Effect
None
Explanation
On successful initiation of data transfer via V.24 this message is output in the message line.
Remedy
Not applicable
Note
Alarm from SW 6.3
100403 V.24 data output active %0 %1
Scan
Serial communication via V.24
Effect
None
Explanation
On successful initiation of data transfer via V.24 this message is output in the message line.
Remedy
Not applicable
Note
Alarm from SW 6.3
100404 Interface already assigned (Port % 0)
Scan
Serial communication via V. 24
Effect
Data transmission does not take place.
Explanation
The serial interface cannot be opened.
Remedy
Check whether:
specified hardware is available
Baud rate and other settings are correct
interface is already in use
Note
Alarm from SW 6.3
100405 V.24: Call parameter missing/incorrect %0
Scan
Seral communication via V.24
Effect
None
Explanation
The interface parameters are incorrect or missing
Remedy
Check parameters. Permitted parameters are workpiece, program, transmission direction (IN, OUT). Combining
the parameters "IN" and device type "Printer" is not allowed.
Note
Alarm from SW 6.3

Siemens AG 2001 All rights reserved 6FC5198–jAB40
SINUMERIK 840C / SIMODRIVE 611–D (DA)
1 Alarms
1.5.1 Alarm description
1–95