Siemens Sinumerik 840C Diagnostics Manual page 130

1 Alarms
1.5.1 Alarm description
110118 Storage of ... not allowed here
Scan
Save NC / NC source / start
Effect
No data transmission
Explanation
Parameter ... stands for NC name
Part programs MFP/SPF can only be stored in a workpiece and GIA data can only be stored under NC data.
Remedy
Position on/in a workpiece or in the case of GIA data to NC data using the data selector.
110119 Data not transferred or incompletely
Scan
Computer link / save start
Computer link / load start / OK
Effect
Not all data transfers, the last file may be incomplete
Explanation
Cause perhaps in error log
Remedy
Rectify cause, restart transmission
110120 Data cannot be read in
Scan
DATA INPUT START
Effect
File has neither been read in the clipboard nor under the target path.
Explanation
Cause (e.g. no write authorization, file opened by ASCII editor) can be seen in the error log
Remedy
Eliminate cause. Restart data input.
Note
Applies as from SW 4.4
110121 Option not available
Scan
On computer link
Effect
–
Explanation
Computer link module not slotted in or not active
Remedy
Activate computer link module (CP)
110122 NCK password not set
Scan
When loading NCK data
Effect
The selected data are not loaded
Explanation
Password required for loading GIA data
Remedy
Set password in diagnosis
110123 Conversion error in workpiece <%1>
Scan
During programming when softkey "Start converter" is pressed or if a workpiece is to be loaded from NCK.
Effect
Faulty part program MPF (SFFs as well if applicable) is (are) created.
Explanation
Displays the name of the workpiece (<%1) with which the conversion error occurred.
Remedy
Eliminate the logged error in the relevant EPF and restart the converter.
Note
Alarm from SW 6.3
110124 Conversion warning in workpiece <%1>
Same as 110123 except a program error is evaluated as a warning.
Note
Alarm from SW 6.3
1–122

Siemens AG 2001 All rights reserved 6FC5198–jAB40
SINUMERIK 840C / SIMODRIVE 611–D (DA)
04/96
01/99
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey