Siemens Sinumerik 840C Diagnostics Manual page 197

04/96
07/97
Error No.
F...
F030
F032
F040
F041

Siemens AG 2001 All rights reserved 6FC5198–jAB40
SINUMERIK 840C / SIMODRIVE 611–D (DA)
Additional Explanation
information
(xx = for diagno-
stic purposes)
Error code / Axis Either irrecoverable errors have
No. been found in the communication
0x01; non–sup- via the drive bus, or the drive soft-
ported ROSCTR ware is no longer consistent. Cause
0x02; illegal is either a defective drive bus inter-
ROSCTR face or a hardware fault on the
0x03; job man- servo control group.
agement "defec-
tive"
0x04; wrong
PDUREF for ac-
knowledgement
0x05; acknowl-
edgement illegal
at that time
0x06; acknowl-
edgement is not
supported
0x07; illegal
PROTID
0x08; illegal
PERLG (odd)
0x09; buffer man-
agement "defec-
tive"
0x0A; illegal PI
code (internal)
0x0B; internal
status of PI re-
start illegal
0x0C; status pro-
cessor in WRITE-
DATA "defective"
0x0D; illegal
transmission pa-
rameter for RE-
FRESH_PI ZUST
NC drive number
Error code / Axis Either irrecoverable errors have
No. been found in the communication
0x20; job man- via the drive bus, or the drive soft-
agement "defec- ware is no longer consistent. Cause
tive" is either a defective drive bus inter-
0x21; illegal sta- face or a hardware fault on the
tus in servo control group.
SET_TRANSPO
0x22; checksum
test incorrect
more than 3
times
0x23; receive
PDU too long
0x24; status 6XX
abort illegal NC
drive number
xx / xx An illegal number of current setpoint
filters (>4) has been entered.
xx / xx An illegal number of speed setpoint
filters (>2) has been entered.
1.5.1 Alarm description
Remedy
Check drive bus cable and plug-on
connectors, take measures to elimi-
nate noise (screening, check
ground connections), replace servo
control module.
Check drive bus cable and plug-on
connectors, take measures to elimi-
nate noise (screening, check
ground connections), replace servo
control module.
Correct number of current setpoint
filters MD1200.
Correct number of speed setpoint
filters MD1500.
1 Alarms
Relevant for
FDD / MSD
FDD / MSD
FDD / MSD
FDD / MSD
1–189