Siemens Sinumerik 840C Diagnostics Manual page 107

04/96
01/99
101005 Faulty load list on MM
Scan
–
Effect
NCK is not powering-up: MMC powers up without NCK
S
Explanation
Last file when booting is not NCK_SYS
S
Remedy
Reinstall NCK software on MMC
101006 MMC–NC data link not ready
Scan
–
Effect
NCK is not powering-up: MMC powers up without NCK
S
Explanation
Internal software error in the data link at driver level
S
Remedy
Install new software on MMC
S
Replace hardware
101008 Remove EPROM submodule on NC–CPU
Scan
–
Effect
NCK is not powering-up: MMC powers up without NCK
Explanation
EPROM module is plugged on NC CPU 386
S
Remedy
See error message: replace CPU, if necessary (if no RESTART EPROM is plugged)
101200 Insufficient memory for UMS
Scan
On start–up of control
Effect
UMS is not loaded.
Explanation
The UMS (of customer or Siemens) cannot be loaded with the current memory configuration because it is larger
than the setting in NC MD 60000 (from SW 4; fixed setting 512 KB until SW 3)
Remedy
Change memory configuration (from SW 4); set machine data MD 60000 accordingly!
Note
Alarm from SW 6.3
101201 Standard memory configuration – error in configuration file
Scan
On start–up of control after data loss
Effect
Booting with standard configuration
Explanation
Memory configuration could not be loaded and activated. Error in user configuration.
Remedy
Create new user configuration
Note
Alarm from SW 6.3
101202 File <%1> not transferred
Scan
Start–up of control if the user wishes to load files to the NC using load840c.ini
Effect
File %1 is not transferred to the NC
Explanation
The user entered the names of the files he wishes to load to the NC in the file called load840c.ini. One of the files
cannot be transferred.
Remedy
Check file name (including path)
Note
Alarm from SW 6.3
102000 Directory does not exist on harddisk
S
Scan
When displaying a data selector in MMC
S
Effect
Reset to configured initial state of data selector
S
Explanation
The data selector tries to display an area no longer available in the data management
Remedy
–

Siemens AG 2001 All rights reserved 6FC5198–jAB40
SINUMERIK 840C / SIMODRIVE 611–D (DA)
1 Alarms
1.5.1 Alarm description
OK softkey
1–99