Siemens Sinumerik 840C Diagnostics Manual page 112

1 Alarms
1.5.1 Alarm description
105013 Standard UMS cannot be loaded
Scan
Power up
Effect
The MMC system boots up without NCK
Explanation
The Siemens configuration file NCMEMCFG.020 does not exist. When transferring the standard configuration, an
error occurred or the NCK signals an error in memory configuration.
Remedy
New system software
105014 Operator panel initialization failed
Scan
Power up
Effect
No power up of MMC
Explanation
Operator panel cannot be initialized
Remedy
Check whether serial driver has been loaded, POWER ON
105015 There is no directory for temporary files!
Scan
Power up
Effect
No power up of MMC
Explanation
There is no directory for temporary files in the data management
Remedy
Reload MMC software
105017 Boot file ... cannot be loaded
Scan
When loading from NCK, PLC or SIMODRIVE 611–D
Effect
–
Explanation
–
Remedy
–
Note
Applies up to SW 4
105017 System file not loaded
Scan
While loading NCK/PLC or SIMODRIVE 611D.
Effect
MMC powers up without NCK and message 105002 appears.
Explanation
No file operation (read, position, ...) could be performed on system file ... or an error has occurred during transmis-
sion. Message 105011 – reference to incorrect file operation – also missing during file operation.
Remedy
Notify system service.
Note
Applies as from SW 5
Error in memory configuration ³ standard configuration loaded
105018
Scan
–
Effect
Boot with standard configuration
Explanation
Memory configuration could not be loaded and initiated. Error in the customer configuration.
Remedy
Create new customer configuration
105020 NCK crash ... 10 following lines
Scan
Permanent
Effect
The register dump for alarms 105031 – 105039 is written into the log
Alarm 105005 has also been output ––> see alarm 105005
Explanation
NCK has crashed and has saved register dump
Remedy
Report register dump from alarm log to Siemens Service, POWER ON
1–104

Siemens AG 2001 All rights reserved 6FC5198–jAB40
SINUMERIK 840C / SIMODRIVE 611–D (DA)
04/96
POWER ON
POWER ON
POWER ON
OK softkey
Acknowledgement key
OK softkey
POWER ON