Siemens Sinumerik 840C Diagnostics Manual page 128

1 Alarms
1.5.1 Alarm description
110103 Memory on NCK is full
Scan
LOAD NC or basic display in AUTOMATIC mode, LOAD WORKPIECE
Effect
Part program will not be transferred
Explanation
None
Remedy
Delete part programs no longer needed from the NCK
110104 Error in data/part-program ...
Scan
LOAD NC or AUTOMATIC basic display, LOAD WORKPIECE
Effect
Data are not transferred or only partly
S
Explanation
NC data to be loaded have errors
S
Read error on hard disk when executing from hard disk
Remedy
Check data
110105 Error during job processing
Scan
LOAD NC, SAVE NC or AUTOMATIC basic display, LOAD WORKPIECE
Effect
–
Explanation
–
Remedy
–
110107 NC data/part program cannot be created here
Scan
SAVE NC / NC SOURCE / START
MANAGEMENT / COPY / PASTE
DATA IN-OUT / BUFFER / INSERT
Effect
Data are not saved, copied or inserted in buffer
Explanation
The data cannot be stored in the current directory
Remedy
Select a different directory
110108 There is no workpiece . . .
Scan
(AUTOMATIC MODE)
Effect
Workpiece will not be loaded
Explanation
The workpiece required by the NCK does not exist in the MMC
Remedy
Check entered names
110109 Only workpieces/NCK data can be loaded
Scan
LOAD NC / START
Effect
None
Explanation
Only workpieces or NCK data can be loaded
Remedy
Using the data selector, select a workpiece under LOCAL or GLOBAL or an NCK object under a workpiece or
from NC data
110110 No access to SPF0
Scan
SAVE NC / NC SOURCE / START
Effect
SPF0 is not saved
Explanation
The name SPF0 is not permissible
Remedy
Deselect from SPF1
1–120

Siemens AG 2001 All rights reserved 6FC5198–jAB40
SINUMERIK 840C / SIMODRIVE 611–D (DA)
04/96
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey