Siemens Sinumerik 840C Diagnostics Manual page 188

1 Alarms
1.5.1 Alarm description
0x0408 Status
0x0411 –
0x0412 Message
length
0x0413 Task ID
0x0414 –
0x0415 Task ID
0x0416 –
0x0417 Task ID
0x0418 Task ID
0x0421 Protocol ID
0x0422 Message type
0x0423 Service ID
0x0424 Variable length Error in data transmission
0x0431 Drive type
1= FDD
2 = MSD
0x0432 Filling level
(time of 611D
error)
0x0433 File ID
0x0434 File ID
0x0435 File ID
0x0501 Status
0x0502 Status
0x0510 Order no.
0x0520 Task ID
0x0601
0x0602
0x0603
0x0604
0x0605
0x0606
0x0607
0x0608
0x0610
1–180
Queue transmission error
Checksum error on receiving
Message length exceeded on receiving
Timeout on transmitting
Timeout + message unknown on transmit-
ting
Timeout on receiving
Timeout +message unknown on receiving
Abort on transmitting
Abort on receiving
Error in data transmission
(unknown protocol ID)
Error in data transmission
(unknown message type)
Error in data transmission
(unknown service ID)
(unknown variable length)
Timeout on firmware booting
Abort of firmware booting due to 611D
system error
An error occurred while reloading the drive
software from the MMC. This can happen if
NCK Power On or PLC restart has been
given during drive booting.
Error in boot sequence
Error in boot file
No ADS block available
No ADS send possible
Acknowledgement cannot be allocated
Message to illegal software component
Error on drive bus formation or data trans-
mission
(write FIFO not empty)
Reserved
Error on bus formation: timeout or CRC er-
ror during PCU initialization
Error on bus formation: timeout or CRC er-
ror on timer initialization in PCU
Reserved
Sign–of–life error 611D
Invalid DCM interrupt (no timeout, no CRC)
Reserved
Reserved

Siemens AG 2001 All rights reserved 6FC5198–jAB40
Contact service
Replace hardware
Replace hardware
Replace hardware
Increase cycle times
Replace hardware,
Increase cycle times
Replace hardware,
Increase cycle times
Replace hardware,
Increase cycle times
Replace hardware
Replace hardware
Contact service
Contact service
Contact service
Contact service
Replace hardware
(control module 611D, drive bus or
DCM), increase cycle times
Replace hardware
(control module 611D, drive bus or
DCM)
Switch control off/on. If the error
then still occurs, the 611D firmware
must be re–installed.
Re–install 611D firmware, contact
Service
Re–install 611D firmware, contact
Service
Contact service
Contact service
Contact service
Contact service
Replace hardware:
NC module, control module 611D,
drive bus cable
Replace hardware:
control module 611D, NC module
Replace hardware:
control module 611D, NC module
Ring programming with GI or
eliminate gantry axes, replace 611D
control module, wrong default for
speed controller clock pulse in stan-
dard control system with SW ver-
sions below SW 5
Replace NC hardware
SINUMERIK 840C / SIMODRIVE 611–D (DA)
04/96
07/97