Siemens Sinumerik 840C Diagnostics Manual page 180

1 Alarms
1.5.1 Alarm description
165034 Conversion has not been switched on
Scan
Loading drive machine data
Effect
Illegal data in drive
Explanation
–
Remedy
Repeat operation
Note
Applies as from SW 5.4.
165035 MD for motor/p section comb. not preset
Scan
Drive MD, axis (FDD): select motor
Effect
Drive is not parameterized
Explanation
There are no standard data for this motor/PS combination
Remedy
Select a different motor or motor from another manufacturer
165036 Not a valid drive number
Scan
Saving and loading MD of one individual drive
Effect
Selected function is not executed
Explanation
An illegal drive number has been entered
Remedy
Enter a legal drive number
165037 Boot file drive n. not saved
Scan
Saving BOOT for one or all drives
Effect
Current drive status lost after next reset
Explanation
No communication with drive
Remedy
Save BOOT configuration, NCK reset, repeat operation
165038 Drive configuration has not been loaded
Scan
Loading user drive machine data
Effect
No connection to drives
Explanation
The loaded MD file does not contain a configuration
Remedy
Load file with configuration data
165039 No communication to the digital drives
Scan
Saving, loading drive MD
Effect
Function is not executed
Explanation
The stated configuration is accepted
Remedy
Save BOOT configuration, NCK reset, repeat operation
165040 Only user configuration can be changed
Scan
Softkey "Configure memory"
Effect
Function is not performed
Explanation
Standard or on-line configuration selected accidentally.
Remedy
Select user setting under "File functions"
Note
Applies as from SW 4
1–172

Siemens AG 2001 All rights reserved 6FC5198–jAB40
SINUMERIK 840C / SIMODRIVE 611–D (DA)
04/96
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey