Siemens Sinumerik 840C Diagnostics Manual page 140

1 Alarms
1.5.1 Alarm description
Note
You will find below a list of all possible alarms and messages that can occur in the SIMULATION area.
The messages and alarms are self–explanatory or their explanation is obvious from the last operator action. The
majority of alarms and messages point to a programming error in the blocks of the simulation program. An expla-
nation of the programming functions is beyond the scope of this documentation. Please refer to the Programming
Guide.
Some alarms and messages include an identifier %... in their formatting. These are replaced in the display by the
cause, e.g.:
141497 "Workpiece %1 is being loaded"
Display:
141497 "Workpiece PART 3 is being loaded"
141102 "Error on workpiece selection !"
141104 "No program selected !"
141105 "Select. allowed only after end of prog./RESET"
141106 "Workpiece empty, please make new selection"
141107 "Program selection error! Reselect tool!"
141122 "Scale modification not allowed !"
141123 "Illegal scale value !"
141124 "Coordinate rotation not allowed !"
141130 "Turning allowed in perspective view only !"
141132 "Function not allowed with only one view"
141134 "Cut allowed with 3D and side view !"
141135 "Please select numerical input."
141136 "Representation no longer possible"
141137 "A cut is not possible in TURNING mode."
141140 "Please exit the vertical menu first"
141141 "No end–of–program (M02/M30/M17) programmed"
141142 "Program stop due to M0/M1."
141490 "Memory limitation, please terminate simulation!"
141495 "Parameter save in progress"
141496 "Initialize simulation"
141497 "Workpiece %1 is being loaded."
141498 "Internal error ! Result might be faulty !"
141499 "Internal error ! Please end simulation!"
142001 "No blank available !"
142002 "No tools set up !"
142003 "No workholder available !"
142004 "Error on loading machine data !"
142005 "Error on loading R parameters"
142006 "Error on loading the ZOA data !"
1–132

Siemens AG 2001 All rights reserved 6FC5198–jAB40
SINUMERIK 840C / SIMODRIVE 611–D (DA)
04/96