Siemens Sinumerik 840C Diagnostics Manual page 49

04/96
09/01
3000 General programming error
S
Explanation
A general programming error which cannot properly be explained has been made in one block in the program.
S
Division by 0
S
A G function which does not exist has been programmed
S
An R parameter which does not exist has been programmed
S
No +,–, /," has been programmed in the R parameter chaining
S
Range of values has been exceeded with R parameter calculation
S
No M19 function allowed with active G96 "Constant cutting rate"
S
Number of decades exceeded (M, S, T, D, H, L, P, F)
S
Subroutine number of passes P not programmed directly behind L
S
Main block ":" programmed in subroutine
S
Two decimal points programmed
S
Decimal point programmed with M, S, T, D, H, L, P
S
More than 8 decades programmed
S
The programmed axis values exceed the travel range limits with the set input resolution
S
Auxiliary functions D, F, S or T are programmed with a minus sign.
S
SW 3 and higher, block search to a spline interpolation coefficient block
S
The F word in G501 exceeds the value range or is negative.
S
Remedy
Check the incorrect block in the "Correction block" display
S
The cursor is placed on the incorrect word, if possible
S
The block number of the incorrect block is positioned behind the alarm number in the alarm line.
S
Correct the F word accordingly.
Example:
Note
Alarm is displayed with reference to channel

Siemens AG 2001 All rights reserved 6FC5198–jAB40
SINUMERIK 840C / SIMODRIVE 611–D (DA)
3000 1 N0010
Acknowledgement key
General programming error
Alarm number
Channel number
Block number "N10" which contains errors
Alarm text
1 Alarms
1.5.1 Alarm description
1–41