Siemens Sinumerik 840C Diagnostics Manual page 106

1 Alarms
1.5.1 Alarm description
101002 NCK software not available on hard disk
Scan
–
Effect
NCK is not powering-up: MMC powers up without NCK
S
Explanation
Required data for loading not available in defined directory
S
Remedy
Install NCK software on MMC
101002 NCK user data being loaded
Scan
When user data are being loaded.
Effect
None
Explanation
Data in user/NC/data directory being loaded
Remedy
Note
Alarm in SW 5 and higher
101003 Checksum error when booting the NCK
Scan
–
Effect
NCK is not powering-up: MMC powers up without NCK
S
Explanation
Faulty loaded file (wrong checksum or wrong format)
S
Remedy
POWER ON
S
Re-install NC software, if necessary
Note
Applies for SW 2 only
101003 User file not loaded
Scan
At system start
Effect
File in the user/NC/data directory is not loaded.
Explanation
No file operation (read, position, ...) could be performed on the user file ... or an error occurred during transfer. In
the case of file operations, message 105011 is not issued (a reference to the faulty file operation).
Remedy
Correct the data in the user/NC/data directory.
Note
Alarm in SW 5 and higher
101003 Error in NCK/user/data load
Scan
At system start
Effect
Data in the directory user/NC/data are not loaded into the NCK
Explanation
–
Remedy
Correct data in the directory user/NC/data. Only GIA data (file name GIA) and IKA data (file names IKA1, IKA2,
IKA3) should be stored there.
Note
Applies from SW 3 to SW 4.4
101004 MMC–NC data link not ready (log)
Scan
–
Effect
NCK is not powering-up: MMC powers up without NCK
S
Explanation
Software error in transport protocol
S
Faulty loaded file
S
Remedy
POWER ON
S
Replace hardware, reinstall software
1–98

Siemens AG 2001 All rights reserved 6FC5198–jAB40
SINUMERIK 840C / SIMODRIVE 611–D (DA)
04/96