System Errors - Siemens Sinumerik 840C Diagnostics Manual

04/96
01/99
165077 Pole pair no. (ratio MD x130/MD x400) illegal
Scan
Softkey "Calculate controller data (MSD only)"
Effect
The controller data have been calculated, the machine data concerned has been given a suitable default value.
Explanation
The pole pair no. (ratio rated frequency (MD 1134 and MD 2134) / rated speed (MD 1400 and MD 2400) is illegal.
Remedy
If necessary, correct value and repeat function.
Note
Applies as from SW 5.4
165078 MIC %1
Scan
In the machine data dialog (MDD) when softkey "Start conversion" is pressed
Effect
The target data record is not created.
Explanation
An error (e.g. syntax error) has occurred in the configuration file that belongs to the metric/inch conversion. The
error message contains a line number and a description of the cause of the error or only a general error text that
cannot be assigned to a specific line number.
Remedy
Eliminate the error in the configuration file (see conversion data in file CONFIG).
Note
Alarm from SW 6.3
300000 System error
Scan
Cyclic after control startup
Effect
Machining stops, interlocking of NC Start and Mode Group Ready
Explanation
Additional Additional
information 1 information 2
(error no.)
0x0001 Task ID
0x0002 Task ID
0x0003 Task ID
0x0004 Task ID
0x0011 Protocol ID
0x0012 Message
frame type
0x0013 Service ID
0x0014 Variable length Unknown protocol variable length
0x0022 Task ID
0x0023 Pointer
(set/actual)
0x0102 Version
(set/actual)
0x0103 Length
(set/actual)
0x0301 Status
0x0302 Status
0x0303 Status
0x0304 Status
0x0401 Drive no.
0x0402 Message
frame type
0x0403 Message
frame type
0x0404 –
0x0405 –
0x0406 –
0x0407 –

Siemens AG 2001 All rights reserved 6FC5198–jAB40
SINUMERIK 840C / SIMODRIVE 611–D (DA)
Explanation
Opcode received unknown
Message received unknown
Faulty buffer type
No queues available
Unknown protocol ID
Unknown protocol message type
Unknown protocol service ID
Incorrect NC/servo/drive address
Put_message pointer error
Version error of boot files
Incorrect length of boot files
PI service initialization error
PI service execution error
PI service message error
PI service abort error
Command with illegal drive no.
Command with illegal header
(transmission)
Command with illegal header (reception)
Management overflow on transmitting or-
ders
Management overflow on transmitting of
acknowledgements
Management overflow on receiving orders
Management overflow on receiving
acknowledgements
1 Alarms
1.5.1 Alarm description
OK softkey
POWER ON
Remedy
Contact service
Contact service
Contact service
Contact service
Contact service
Contact service
Contact service
Contact service
Contact service
Contact service
Create boot files again
Create boot files again
Contact service
Contact service
Contact service
Contact service
Contact service
Contact service
Contact service
Contact service
Contact service
Contact service
Contact service
1–179