Siemens Sinumerik 840C Diagnostics Manual page 122

1 Alarms
1.5.1 Alarm description
110032 Error in archive file
Scan
DATA IN-OUT / DATA INPUT / START
Effect
Data are either not read in or are read in with errors
Explanation
Archive list is faulty
Remedy
Correct
110033 Error on writing the archive
Scan
DATA IN-OUT / DATA OUTPUT / ... / START
Effect
Data read out has been interrupted
Explanation
Data is not evaluated by output medium (external device) (hardware fault)
Remedy
Start again
110034 Timeout >= 0 and <= 60 seconds
Scan
DATA IN-OUT / DEVICES / EDIT / STORE
DATA IN-OUT / DEVICES / SELECTION
Effect
Data cannot be stored/no device selection
Explanation
Time must be in the specified range
Enter 0 ≤ time ≤ 60 seconds
Remedy
110035 Wrong output medium parameterized
Scan
DATA IN-OUT / FORMAT
DATA IN-OUT / PRINT
Effect
None
Explanation
Parameterized floppy cannot be formatted, print command cannot be sent to parameterized universal interface
Remedy
Change interface parameterization
110036 No data for ...
Scan
LOAD NC / SHOPFLOOR SHEET / WORK SCHEDULE / MACHINING OPERATION
LOAD NC / SHOPFLOOR SHEET / WORK SCHEDULE
LOAD NC / SHOPFLOOR SHEET / BLANK
Effect
None
Explanation
The corresponding data for the shopfloor sheet is not available
Remedy
Create data
110037 The hard disk is full
Scan
DATA MANAGEMENT / COPY / COPY / DATA IN-OUT / DATA INPUT /
START / SAVE NC / SOURCE NC / START
Effect
Data cannot be stored or created
Explanation
–
Remedy
Delete data no longer required
110038 Syntax error in job list line ...
Scan
LOAD NC / START
DATA IN-OUT / DATA OUTPUT / WORKPIECES / START
Effect
Data are not archived/loaded into the NC
Explanation
Syntax error in job list
Remedy
Correct
1–114

Siemens AG 2001 All rights reserved 6FC5198–jAB40
SINUMERIK 840C / SIMODRIVE 611–D (DA)
04/96
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey