Siemens Sinumerik 840C Diagnostics Manual page 147

04/96
146203 "After axis etc: do not change system of units"
146204 "Too many axes programmed in the block"
146205 "Too many radii and/or chamfers in the block"
146206 "Too many angles programmed in the block"
146207 "Too many interpolation parameters in block"
146208 "Only K parameters allowed here"
146209 "R parameter not allowed as spline coefficient"
146210 "Spline coefficient must be an integer"
146211 "X word not allowed"
146212 "Dwell already programmed in block"
146213 "Stop angle has been corrected 'modulo 360'"
146214 "Negative S value for speed not allowed"
146215 "Too many components for contour def. in block"
146216 "G92 S/ G96 S allowed for leading spindle only"
146217 "Illegal axis setpoint"
146218 "Illegal rotary axis setpoint"
146219 "Illegal modulo rotary axis setpoint"
146220 "G%1 not allowed in this block"
146221 "Axis with act. transformation illegal"
146231 "MD%1: MD could not be read"*
146232 "MD%1: name of radius/chamfer not allowed"*
146233 "MD%1: name of angle not allowed"*
146234 "MD%1: name conflict: radius/chamfer <–> angle"*
146235 "MD%1: addr.ext. not allowed for radius/chamfr"*
146236 "MD%1: address extension not allowed for angle"*
146237 "MD%1: input resolution not allowed"*
146238 "MD%1: axis name not allowed"*
146239 "MD%1: axis not allowed in mode group"*
146240 "MD%1: axis name assigned several times"*
146241 "MD%1: IPO parameters not allowed"*
146242 "MD%1: axis name not allowed for plane"*
146243 "MD%1: G number not allowed as initial setting"*
146253 "Rapid traverse block was generated"
146254 "G15 is not simulated"
* Simulation must be cancelled and a corrected set of machine data activated with the load list by reselec-
ting.

Siemens AG 2001 All rights reserved 6FC5198–jAB40
SINUMERIK 840C / SIMODRIVE 611–D (DA)
1 Alarms
1.5.1 Alarm description
1–139