Siemens Sinumerik 840C Diagnostics Manual page 129

04/96
110111 ... being processed or cycle inhibit
Scan
SAVE NC / NC SOURCE / START / LOAD NC / START
Effect
Data will not be saved to MMC or loaded in NCK
Explanation
The part program either has cycle disable or is being processed
Remedy
Remove disable or discontinue processing
Note
Applies up to SW 2
110112 ... is not a correct NCK name
Scan
LOAD NC / START
Effect
Data are not transferred to NC
Explanation
Error in part program name, e.g. MPF_1
Remedy
Correct name in MMC
110113 No communication to NCK
Scan
(Power up) LOAD NC / START SAVE NC / NC SOURCE
Effect
No data transfer
Explanation
There is no connection to the NCK. A more detailed error diagnosis is entered in the alarm log with message
105011 and possibly 105030 to 105039. Incorrect MDs e.g. IPO cycles too short.
Remedy
Inform system service
110114 ... transmitted incompletely
Scan
Abort AUTOMATIC basic display
LOAD NC / START / ABORT
SAVE NC / NC SOURCE / START / ABORT
Effect
The file has not been transmitted in its entirety to the MMC or the NCK
Explanation
It may no longer be possible to send the complete file to the NCK
Remedy
Save the complete file from the NC again and/or transfer it completely to the NCK
110115 ... : Line is too long
Scan
LOAD NC / START
Effect
Incomplete data transfer
Explanation
Line may not contain more than 120 characters without blanks or 120 characters with blanks in the comments
section.
Remedy
Alter using editor
Note
Applies up to SW 2
110116 No data transmitted for ...
Scan
LOAD NC / ... / START / SAVE NC / ... / START
Effect
–
Explanation
No transferable data was selected
Remedy
Select data that can be transmitted / correct job list
110117 Wrong channel number
Scan
SAVE NC /. .. / START
Effect
No data transmission
The channel number must be  0  4 ( 6 as from SW 4)
Explanation
Remedy
–

Siemens AG 2001 All rights reserved 6FC5198–jAB40
SINUMERIK 840C / SIMODRIVE 611–D (DA)
1 Alarms
1.5.1 Alarm description
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey
1–121