Siemens Sinumerik 840C Diagnostics Manual page 126

1 Alarms
1.5.1 Alarm description
110061 No workpiece in job list line ...
Scan
LOAD NC / START
Effect
Job list processing was interrupted
Explanation
The workpiece name in the LOAD instruction does not exist
Remedy
Change job list
110062 ... not found in job list
Scan
LOAD NC / START
Effect
Job list processing was interrupted
Explanation
The workpiece name in the LOAD instruction does not exist
Remedy
Change job list
110063 No workpiece can be created here
Scan
DATA IN-OUT / DATA INPUT / IN NEW WORKPIECE
Effect
None
Explanation
A workpiece cannot be created at the current location
Remedy
Select the directory PC/USER/LOCAL or PC/USER/GLOBAL
110064 Data type exists already
Scan
Data management / new
Data management / insert from archive
Effect
File is not created / copied
Explanation
The data type can only be created once in the current location.
Remedy
First delete the existing file
110065 Not possible at present
Scan
When data is output through V24 and saved to hard disk at the same time, e.g. from a MPF in the programming. If
file is processed in the PC editor.
Effect
Data is not transmitted.
Explanation
–
Remedy
Wait until the save operation has been concluded in the ASCII editor.
Note
Applies as from SW 4.4
110066 Data in Siemens branch cannot be stored
Scan
Data management / new
Data management / insert from archive
Effect
File is not created / copied
Explanation
File cannot be created in Siemens branch.
Remedy
Move to user branch
110067 Please enter correct archive name
Scan
Data input
Data output
Effect
Function is not processed
Explanation
The archive name must have the syntax of a file name
Remedy
Enter correct name
1–118

Siemens AG 2001 All rights reserved 6FC5198–jAB40
SINUMERIK 840C / SIMODRIVE 611–D (DA)
04/96
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey