Table of Contents
Advertisement
BNC
Adapter
Radio
Figure 21-11 XTS2500 Radio Installed on ACE3600 Chassis - Cable Connections
RTU Port Configuration
To enable MDLC communication over ASTRO IV&D, use the ACE3600 STS (≥V10.50) to
configure the RTU port connected to the XTS25000 radio. For more information, refer to the
MDLC over IP chapter of the ACE3600 STS Advanced Features manual.
The following figures show the port configuration and advanced parameter configuration.
Although these show Port SI1, the same values can be applied to other ports, where relevant.
Port Type
Procedure 21-11 How to Configure the ACE3600 Port for the Astro XTS2500 Digital Radio
1.
In the ACE3600 STS click on the desired site, and open the site view.
2.
In the Port Tab, click on the on-board or plug-in port through which the RTU will
communicate with the XTS2500 radio.
3.
Confirm that the port parameters and data speed are as shown in the screen below.
4.
Define desired links.
5.
If you plan to synchronize the RTU time from the Front End Processor (FEP) in the
Customer Enterprise Network (CEN), specify the IP address of the FEP in the NTP field.
This IP address information is provided by your ASTRO IV&D system operator.
6.
Save the changes.
21-21
Radio Types and Installation Kits
Programming
Cable
(
RKN4106A
Antenna
Cable
(
FKN8434A
Data Cable
(
FKN8516A
Power Cable
(
FKN8515A
)
)
)
)
Advertisement
Table of Contents
