Table of Contents
Advertisement
2) Change TX Power Level High for Freq. Range A from 33.0 to 15.
3) Change TX Power Level High for Freq. Range B from 38.5 to 15.
b.
In the General tab, set the Out of Range Indicator and Imbalanced Coverage
Indicator to Alert & Display.
c.
(Recommended) In the Data tab, enable SNMP Traps. (You can disable it, but
the RTU will only detect a loss of context activation the next time it polls the
radio (every 10 seconds by default).
d.
(Optional) Specify the Mobile Computer IP address. This is the dummy IP
address assigned to the RTU by the radio (by default it is 192.168.128.2). For
each radio, it is recommended to change the last digit in the Mobile Computer IP
address (e.g. to the Unit ID in Trunking systems.)
e.
(CPS R05.00.00 only) In the Advanced tab, make sure that "MOSCAD Data
Enable" is not enabled (not checked.) (For IV&D only. For communication over
analog ASTRO Trunking, leave it enabled.) Set Extended DEK to Enable and
Ignition Switch to Soft Power Off.
3.
Double-click on NAT List -> NAT List Entry 1.
a.
Add an entry to the NAT List:
1) WAN port = MDLC over IP port number (e.g. 2002)
2) LAN port = MDLC over IP port number (e.g. 2002)
3) Static NAT IP Address = Mobile Computer IP Address (e.g. 192.168.128.2).
4) The Mobile Computer address should match the Mobile Computer IP Address
assigned on the Radio Configuration>Radio Wide>Data tab in Step 2 above.
4.
Double-click on Trunking ->Trunking System ->Trunking System 1.
a.
In the General tab, set the Type to ASTRO 25. If the proper system key was
loaded, the System Key field should already be enabled.
b.
Set the ASTRO 25 Home System ID, Home WACN ID and Unit ID to values
obtained from the radio system administrator.
c.
Under Coverage Type, set the type to SmartZone.
d.
In the Astro 25 Channel ID tab, enable the first channel.
e.
In the 700/800 Astro 25 Control Channels tab (700_800 or OBT depending on
the band), enter the control channels with which the data subscriber should be
able to affiliate. Consult your radio system administrator for the list of control
channels.
f.
In the Data tab, enable Packet Data Capable System (PDS), and Terminal Data
and disable (uncheck) Rx Voice Interrupts Data.
5.
Double-click on Trunking ->Trunking Personality ->Trunking Personality 1.
21-12
Radio Types and Installation Kits
Advertisement
Table of Contents
