Table of Contents
Advertisement
RTU Port Configuration
Before using the ACT module with the RTU, configure the communication port to which the
ACT module is connected.
Procedure 23-2 How to Configure the ACE3600 Port for the ACT Module
1) In the ACE3600 STS click on the desired site, and open the site view.
2) In the Port Tab, click on the on-board or plug-in port through which the RTU will
communicate with the ACT Module.
3) Set Media to RS-232, Operation Mode to Async, Connection Type to User Port (Ladder
Controlled).
4) Save the changes.
Generally no other changes are required to Advanced Physical or Link Layer parameters. For
information on the RTU port parameters, see Appendix A: Site Configuration Parameters of
the ACE3600 STS User Guide.
CD - In
6
Not Used
7
CTS - In
8
23-8
Audio Control and Tone (ACT) Module
RTS
Not Used
DTR
Advertisement
Table of Contents
