Table of Contents
Advertisement
Serial Configuration Wizard
-==================================================================-
COM2 Serial Data Port
A) Status
B) IP Protocol
C) Device IP Address
D) Data Baud Rate
E) Configuration
F) Flow Control
G) Serial Mode
H) Custom Inter-Frame Delay
I) Custom Data Buffer Size
Select a letter to choose item, <ESC> for the prev menu, 'Q' to quit wizard
20. Press 'X' to save the changes and exit the wizard. There is no need to power up the iNET
radio. Note that these settings are saved and you do not need to reset them when
powering up the radio unit again.
21. From the Serial Gateway Configuration, press ESC to return to the Main Menu.
Your configuration of the PPP is complete.
RTU Configuration
The RTU port is configured using the ACE3600 STS.
Site Configuration
Procedure 21-31 How to Configure the ACE3600 Port for the iNET 900 Radio
In the ACE3600 STS click on the desired site, and open the site view.
2.
In the Port Tab, click on the on-board or plug-in port through which the RTU will
communicate with the iNET radio.
3.
Confirm that the port parameters and data speed are as shown in the screen below.
Note: If the baud rate of the radio is not the default value (9600), the baud rate of the port
should be configured accordingly.
4.
Define desired links.
5.
Save the changes.
enabled
Point to Point Protocol (PPP)
169.254.0.13
9600
8N1
enabled
Custom
4
64
21-73
Radio Types and Installation Kits
Advertisement
Table of Contents
