Table of Contents
Advertisement
3.
Insert the DC power cable (FKN8510A) connector into the DC power connector on the
radio.
4.
If the RTU is to be installed inside an enclosure, screw the antenna cable (FKN8509A)
into the antenna connector on the radio. Otherwise, an external antenna can be connected
directly to the antenna connector on the radio.
5.
Mount the bracket (#0789971V39 from FHN7066A) on the RTU chassis above the I/O
modules, using the four built-in screws. (See Figure 21-59 below.)
6.
Route the antenna cable (FKN8509A) cable through the small wire clamps along the left
side edge of the RTU chassis, according to the placement of the radio on the chassis, as in
Figure 21-59 and Figure 21-60.
7.
Unscrew the nut and locking washer from the N-type connector at the other end of the
antenna cable. Thread the end of the cable through the opening on the bottom of the
enclosure and screw on the nut and locking washer from outside the enclosure.
8.
Connect the other end of the DC power cable (FKN8510A) to the AUX1A/B connector
on the RTU's power supply module.
9.
Connect the other end of the communication cable (FKN8513A) to the ACE3600 CPU
module port configured for the radio. See RTU Configuration below.
10.
Connect the antenna cable to an external antenna.
21-77
Radio Types and Installation Kits
Advertisement
Table of Contents
