Table of Contents
Advertisement
MMDS05 CONFIGURATION AND OPERATION
This chapter explains how to configure and use your D32EM as part of an MMDS05. For
other parts of system installation or configuration, see the MMDS05 operations manual
(MMDS05OM/D). (If you will use your D32EM as part of an HC05EVS system, go to
Chapter 3 for corresponding information.)
Paragraph 2.1 explains how to set D32EM jumper headers.
considerations pertaining to the MCU you emulate. Paragraph 2.3 explains remaining system
installation.
Note that you can configure a D32EM already installed in the MMDS05 station module
enclosure. To do so, switch off station-module power, remove the panel, then follow the
guidance of this chapter.
Be sure to switch off power if you reconfigure an installed EM. Reconfiguring
EM jumper headers with power left on can damage MMDS05 circuits.
2.1 SETTING D32EM JUMPER HEADERS
Your D32EM has four jumper headers, J1 through J4 and two switch arrays S1 and S2.
Paragraphs 2.1.1. through 2.1.4 explain how to configure these headers and switches.
M68EM05D32/D
MMDS05 CONFIGURATION AND OPERATION
CHAPTER 2
CAUTION
2-1
Paragraph 2.2 explains
MOTOROLA
Advertisement
Table of Contents
