Table of Contents
Advertisement
Radio Types and Installation Kits
RTU Configuration
The RTU port is configured using the ACE3600 STS as follows:
Procedure 21-33 How to Configure the ACE3600 Port for the MDS Radio
1. In the ACE3600 STS click on the desired site, and open the site view.
2. In the Port Tab, click on the on-board or plug-in port through which the RTU will
communicate with the MDS radio.
3. Confirm that the port parameters and data speed are as shown in the relevant screen below.
Note: If the baud rate of the radio is not the default value (9600), the baud rate of the port
should be configured accordingly.
4. Define desired links.
5. Save the changes.
Figure 21-61 RTU Site Configuration for MDS 9810 Spread Spectrum/4710 UHF Transceiver
Radio– Port Type Parameters
Figure 21-62 RTU Site Configuration for MDS 9710A- 900 MHz Radio– Port Type Parameters
21-79
Advertisement
Table of Contents
