Motorola ACE3600 RTU Owner's Manual page 250

Programmable remote terminal unit
Hide thumbs Also See for ACE3600 RTU:
Table of Contents

Advertisement

Port Type (for Astro IV&D Digital Radio)
Procedure 21-2 How to Configure the ACE3600 Port for the Astro IV&D Digital Radio
1.
In the ACE3600 STS click on the desired site, and open the site view.
2.
In the Port Tab, click on the on-board or plug-in port through which the RTU will
communicate with the XTL5000/XTL2500 radio.
3.
Confirm that the port parameters and data speed are as shown in the screen below.
4.
Define desired links.
5.
If you plan to synchronize the RTU time from the Front End Processor (FEP) in the
Customer Enterprise Network (CEN), specify the IP address of the FEP in the NTP field.
This IP address information is provided by your ASTRO IV&D system operator.
6.
Save the changes.
Figure 21-5 RTU Site Configuration for MDLC over ASTRO IV&D – Port Type Parameters
Advanced Parameter Configuration (for Astro IV&D Digital Radio)
Figure 21-6 RTU Site Configuration for MDLC over ASTRO IV&D – Advanced Parameters
21-9
Radio Types and Installation Kits

Advertisement

Table of Contents
loading

Table of Contents