Table of Contents
Advertisement
4.
(Optional) If it is desirable to reduce transmission time, consider reducing Tx Preamble
Duration from 960ms to 60-120ms. The preamble duration can also be reduced if no/few
radios in the system use the scan feature. If priority scan is used, or for Scan List
members with high traffic or long transmissions, or for dual capacity direct mode
channel, consider increasing Tx Preamble Duration. For details, consult your radio
system administrator.
5.
Under Accessories, verify that Ignition Sense is set to On/Off Or Ignition.
6.
Under Network, verify that the CAI Network number (default 12) is identical for all
radios in the system.
Verify that the CAI Group Network number (default 225) is identical for all radios in the
system. (This corresponds to the '225' in the port's Default group IP address 225.0.0.1.)
Verify that under Forward to PC, the Via USB option is selected (required for time sync
and broadcast). (In older CPS versions, verify that Forward to PC is checked.)
7.
Under Contacts->Digital, add a new Group Call with ID '1'. Rename it MOSCAD. (This
corresponds to the '1' in the port's Default group IP address 225.0.0.1.)
8.
Under Rx Group Lists->Digital->List 1, add MOSCAD to Members. This allows the
RTU/FIU to receive group calls over MotoTrbo.
9.
Under Channels->Zone<n>->Channel1, set the TX and RX frequencies as required.
Verify that the color code and the repeater slot are equal in all radios in the group.
10.
If you expect if a high amount of over-the-air contention on your channel, select
Enhanced Channel Access for optimal data reliability. Otherwise, for optimal data
throughput, leave this feature disabled (unchecked).
11.
From the File Menu, select Save to save changes to the radio.
12.
From the File Menu, select Write Device to download the configuration to the radio.
Note: The radio configuration must match the repeater topology (direct mode, single repeater,
IP site connect.)
For more information on configuring the MotoTrbo radio and the ACE3600 RTUs for MDLC
over MotoTrbo, see the MDLC over MotoTrbo section of the ACE3600 STS Advanced
Features manual. For information on adding IP addresses to the IP conversion table and
downloading to the relevant attached RTUs, see the Operation chapter of the ACE3600 STS
User Guide.
XPR4350/XPR4380/DM3400/XiR M8220/DGM4100 Options for ACE3600
One of the following MotoTrbo options must be ordered with the F7583A/F7584A models:
Option Name
ADD: XPR4350 Radio 403-470 MHz for NAG
ADD: XPR4350 Radio 450-512 MHz for NAG
ADD: XPR4350 Radio 136-174 MHz for NAG
ADD: XPR4380 Radio 800/900 MHZ for NAG
21-54
Radio Types and Installation Kits
Option Number
V751AA
V751AB
V751AC
V751AD
Advertisement
Table of Contents
