Table of Contents
Advertisement
RTU Port Configuration for the CDM750 Radio
To enable MDLC communication using CDM750 radios, use the ACE3600 STS site
configuration utility to configure the ACE3600 RTU plug-in port connected to the radio.
The following figures show the port configuration and advanced parameter configuration.
Although these show Port PI1, the same values can be applied to port PI2 as well, where
relevant.
Port Type
Procedure 21-17 How to Configure the ACE3600 Port for the CDM750 Radio
1.
In the ACE3600 STS, click on the desired site, and open the site view.
2.
In the Port Tab, click on the plug-in port through which the RTU will communicate with
the radio.
3.
Confirm that the port parameters and data speed are as shown in the screen below.
4.
Define desired radio links and zones if necessary.
5.
Save the changes. Generally no other changes are required to Advanced Physical or Link
Layer parameters.
Figure 21-17 RTU Site Configuration for MDLC over CDM750 Radio – Port Type Parameters
Programming the CDM750 Radio using CPS
The CDM750 radio is programmed for ACE3600 in the factory and is ready for
communication. For user programming of site-specific parameters, follow the instructions
below.
Radio Connections
To program the CDM750 radio with Customer Programming Software (CPS), the radio is
connected to a PC using the standard Radio Interface Box (RIB).
Procedure 21-18 How to Connect the CDM750 Radio to the CPS
1.
Connect one end of the programming cable (PMKN4004) to the radio Accessory
connector and the other end to the 25-pin connector on the RIB (RLN4008). The RIB
and cable are not supplied and must be ordered separately.
2.
Using the 9-pin interface cable (3080369B72), connect the RIB to the serial port of a PC
on which the CDM750 CPS software (HVN9025) is installed.
3.
Connect the RIB to a power RIB power supply or 9V battery.
21-30
Radio Types and Installation Kits
Advertisement
Table of Contents
