Ace Ip Gateway Leds Behavior - Motorola ACE3600 RTU Owner's Manual

ACE IP Gateway LEDs Behavior

The table below describes the behavior of the LEDs on the ACE IP Gateway module.
LED Name
PWR
ERR
RST
CONF
H1 LNK1
H1 LNK2
PI1 TX
PI1 RX
Table 20-4 ACE IP Gateway LEDs Behavior
Description
Power LED
Bicolor LED (Red, Green)
Error Logger Status LED
Bicolor LED (Red, Green)
Reset LED
Bicolor LED (Red, Green)
Configuration LED
Bicolor LED (Red, Green)
USB Host1 LNK (link)
Green LED
USB Host2 LNK (link)
Green LED
Plug-in Port 1 – TX
(transmit)
Green LED
Plug-in Port 1– RX (receive)
Green LED
Status
Flashing Red – Power exists; CPU FPGA not
loaded.
Green – Power exists; CPU is running from a
recognized power supply (one of the six
power supply options.)
Red – Failure on power-up. CPU is running
from an unrecognized power supply.
OFF – No new errors or warnings.
Green – New message logged.
Orange – New warning logged.
Red – New error logged.
Green – On startup
OFF – Successful power-up or restart.
Red – Power-up or restart failed.
OFF – Configuration was not loaded.
Green – Configuration was loaded.
Red – Configuration error.
ON – A USB device is connected.
OFF – No link exists between the CPU and
the device.
ON – A USB device is connected.
OFF – No link exists between the GW and
the device.
ON- Transmitting Data
ON – Receiving Data
20-10
ACE IP Gateway Module