Table of Contents
Advertisement
Figure 21-44 RTU Site Configuration for MDLC over MOTOTRBO Radio – Port Type Parameters
4. Define the desired Line links.
5. Configure the Advanced Link Layer parameters as in the screen below.
Figure 21-45 RTU Site Configuration for MDLC over MOTOTRBO Radio – Advanced Configuration
Note: Setting the 'Enable sync' parameter to Enable is for time synchronization only.
Note: Default group IP address is required for sending group calls (MDLC setcalls). The
specific IP address should be set in the radio CPS as described below (otherwise RTUs will
not be able to send or receive group calls from the radio).
6. Save the changes. Generally no other changes are required to Advanced Physical
parameters.
Advanced Parameter Configuration
The STS provides default settings for advanced port parameters for use with the MotoTrbo
radio. These settings should be used.
21-52
Radio Types and Installation Kits
Advertisement
Table of Contents
