Table of Contents
Advertisement
Radio Configuration
External Modem Port
iNET radios can be configured to work with the External Modem port on ACE3600 RTUs (see
Configurations 1, 2 and 3 above.)
Use the iNET radio programming software to program the AP (Access Point) and then the
remote with the following settings.
Note:
Radio firmware should be 4.4.0 or above.
IP Address refers to the Ethernet port IP and not the "over the air" IP.
The initial screen is as follows:
MDS iNET 900
Starting Information Screen
-==================================================================-
Device Mode:
Device Name:
Network Name:
IP Address:
Device Status:
Uptime:
Firmware Version:
Hardware Version:
Serial Number:
1.
Press 'G' and the Main Menu will be displayed.
2.
Press 'D' and the Serial Gateway Configuration Menu will be displayed.
3.
Press 'D' to enable COM2 (if it is not enabled). Use the SPACE bar to cycle between
Enabled and Disabled. COM2 should be Enabled and COM1 Disabled. Press ENTER
once Enabled is shown.
4.
Press 'E' and the Serial Configuration Wizard will be displayed. This wizard will assist
you in the configuration of your available Serial Data Ports.
Access Point
AP Demo Set I
Demo Set l
169.254.0.12
Operational
01 hrs, 51 min
4.4.0
1.0.3
1069975
Press 'G' to go to Main Menu
21-67
Radio Types and Installation Kits
Advertisement
Table of Contents
