Motorola ACE3600 RTU Owner's Manual page 257

Programmable remote terminal unit
Hide thumbs Also See for ACE3600 RTU:
Table of Contents

Advertisement

e.
f.
5.
Double-click on Trunking ->Trunking System ->Trunking System 1 (for trunked only.)
a.
b.
c.
d.
e.
f.
g.
h.
6.
Double-click on Trunking ->Trunking Personality ->Trunking Personality 1 (for trunked
only.)
a.
b.
7.
From the File Menu, select Save to save changes to the radio.
8.
From the File Menu, select Write Device to download the configuration to the radio.
XTL5000/XTL2500 Radio Models and Options for ACE3600
The XTL5000/XTL2500 radio installation kit is used with one of the following XTL5000/
XTL2500 radios:
Description
XTL5000 Mobile 10-35 W, 764-870MH
XTL5000 UHF R1 Mobile 10-40 W 380-470
Set Tx Voice/Signal Type to Non-Astro.
Set Transmit Power Level to High.
In the General tab, if the proper system key was loaded, the System Key field
should already be enabled.
Set the Type to II.
Set the Type II System ID, and Connect Tone to values obtained from the radio
system administrator for the site.
Under Coverage Type, set the type to Disabled.
In the Type II tab, set the Individual ID to the value obtained from the radio
system administrator for the site.
Set the Affiliation type to Automatic.
In the Channel Assignment tab, enter the Rx and Tx channel ranges. Consult
your radio system administrator for the list of values.
In the OBT Control Channels tab, set the RX Frequency and TX Frequency of
each control channel with which the data subscriber should be able to affiliate.
Consult your radio system administrator for the list of control channels.
In the General tab, set the Protocol Type to II and set the System ID to the value
obtained from the radio system administrator for the site. Make sure that the
Time Out Timer is set to 3 (for 60 sec). Check that the Type II Individual ID is
set to the value obtained from the radio system administrator for the site.
In the Talkgroup tab, set the radio talkgroup value in hexadecimal. Consult your
radio system administrator for the talkgroup information. (Note: Talkgroup for
voice in analog trunking is the same for voice and data on analog trunk.
Nomenclature
M20URS9PW1 N
M20QSS9PW1 N
21-16
Radio Types and Installation Kits
Band
764 - 870 MHz
380 - 470Mhz

Advertisement

Table of Contents
loading

Table of Contents