Switching The Unit On And Off; Dentsply Sirona - DENTSPLY inLab MC X5 Operating Instructions Manual

5 Commissioning
5.2 Putting the unit into operation
44
5.2.6

Switching the unit ON and OFF

NOTICE
Do not put the unit into operation at low temperatures!
If you move the unit to the operating site from a cold environment,
condensation may form and result in a short circuit.
Within the machine, grease depots are included for lubricating
components that can cause error messages at low temperatures.
✔
Install the unit at room temperature.
➢ Wait until the unit has reached room temperature and is absolutely
dry (for at least one hour)
The unit is dry and can be put into operation.
NOTICE
Do not adjust the line voltage
The unit automatically adjusts to the line voltage.
Switching the unit on
✔
The unit is connected to the power supply.
1. The main switch on the left rear side of the unit is set to position I
(ON).
It takes 10-15 seconds for the front LED to light up green.
2. Press the ON/OFF button on the front panel.
The unit switches itself on and the machining chamber is illuminated
white or yellow (white only, if the workpiece holder is level with the
clamp of the support arm).
Switching the unit off
✔
The unit has finished the machining operation.
➢ Briefly press the ON/OFF button on the front panel.
When you let go of the button, the unit switches off.

Dentsply Sirona

Operating Instructions inLab MC X5
64 78 759 D3608
D3608.201.01.07.02 10.2017