Connecting The Pc/Interfaces; Repacking; Storage; Dentsply Sirona - DENTSPLY inLab MC X5 Operating Instructions Manual

Dentsply Sirona

Operating Instructions inLab MC X5
64 78 759 D3608
D3608.201.01.07.02 10.2017
4.7

Connecting the PC/interfaces

The "Ethernet (RJ45)" port is located at the rear of the unit (see
Connections [ → 14]) and can be used for connecting the PC to the
machine. Use a network cable to do this (LAN connection).
➢ Connect the unit with the network card of your PC using the provided
network cable.
IMPORTANT
If you wish to integrate the inLab MC X5 into an existing network then
please contact your responsible IT technician.
4.8

Repacking

✔
The coolant tank is empty.
✔
The main switch on the back side of the unit is set to the 0 (OFF)
position.
1. Disconnect the power cable and the connecting cable from the back
side of the unit and stow them away.
2. Check the unit for completeness according to the scope of supply!
3. Pack the unit securely and use the transport locks provided for tool
spindles, workpiece holders and tool magazines.
4.9

Storage

Store the unit in a closed and dry room at a temperature of -10°C to 50°C
for a maximum period of 12 months.
4 Transportation and installation
4.7 Connecting the PC/interfaces
33