Process Start - DENTSPLY inLab MC X5 Operating Instructions Manual

Dentsply Sirona
Operating Instructions inLab MC X5
64 78 759 D3608
D3608.201.01.07.02 10.2017
6. Now slightly tighten the screws on the fixing ring with the help of the
torque wrench for the tool holder in an alternating manner. Make sure
that the fixing ring is parallel to the base and is not slanted. If the ring
is parallel, tighten the screws finally using the torque wrench at the
preset torque. The required torque is reached if a clicking/ popping
sound is heard when tightening the screws. Use only the torque
wrench supplied with the workpiece holder from Sirona for fixing the
workpiece.
7. Close the door of the machine after inserting and fixing the multi-
block holder, and follow the instructions of the software.
6.2.6

Process start

Then simply proceed as prompted by the software.
6 Operation
6.2 Machining processes
69