Loading With The Workpiece (Round Blank); Dentsply Sirona - DENTSPLY inLab MC X5 Operating Instructions Manual

Dentsply Sirona

Operating Instructions inLab MC X5
64 78 759 D3608
D3608.201.01.07.02 10.2017
In order to equip the multi-block holder, proceed as follows:
CAUTION
Risk of injury while reaching out to the processing chamber
There is the risk of cut injuries and crushing through sharp tools and
moving parts.
➢ Make sure that you do not touch the sharp tools and moving parts.
1. Place the selected block in the proposed block fixation of the multi-
block holder at the position defined by the software. The possible
positions are marked and numbered on the upper side of the multi-
block holder by an engraving.
2. Screw the block down tightly with the spherical pressure screw with
the aid of the block clamping tool for the multi-block holder.
6.2.4

Loading with the workpiece (round blank)

CAUTION
Risk of injury while reaching out to the processing chamber
There is the risk of cut injuries and crushing through sharp tools and
moving parts.
➢ Make sure that you do not touch the sharp tools and moving parts.
During each change, ensure clean contact surfaces of all parts;
otherwise, the fixation and the correct positioning cannot be guaranteed.
Depending on your choice of materials, also follow the processing
instructions of the manufacturer.
The workpiece holder is designed to hold workpieces of different
materials in the round blank form. The format for holding is a diameter of
∅ = 98.5 mm. The workpiece holder automatically moves to the loading/
unloading position.
In order to load the workpiece holder with a workpiece, proceed as
follows:
1. Open the door of the machine by pressing the Unlock door button.
The mandrel and the workpiece holder have automatically moved
to the loading position beforehand.
6 Operation
6.2 Machining processes
63