Before Processing Titanium Workpieces; Filling And Connecting The Coolant Tank - DENTSPLY inLab MC X5 Operating Instructions Manual

7 Maintenance and cleaning
7.9 Procedure when processing Medentika-PreFace® abutment semi-finished products made of titanium
90
7.9.2

Before processing titanium workpieces

CAUTION
Risk of injury while reaching out to the processing chamber
There is the risk of cut injuries and crushing through sharp tools and
moving parts.
➢ Make sure that you do not touch the sharp tools and moving parts.
CAUTION
Risk of injury through cutting and grinding tools
There is risk of cuts through sharp edges of accessible parts and the use
of rotating cutting and grinding tools that are sharp and/or pointed.
CAUTION
Risk of injury through sharp-edged restorations and material residues
There is risk of injury through sharp-edged restorations as well as sharp-
edged material residues.
➢ Remove the restored objects and material residues carefully after
the processing.
➢ Pay attention to the sharp-edged material residues while cleaning
the processing chamber.
7.9.2.1

Filling and connecting the coolant tank

Connect the tank intended for titanium processing. In addition, follow the
instructions for filling the tank with the coolant DentaLub when processing
titanium workpieces.
NOTICE
The tank may become unusable
Regularly check the condition of the deposited solids and clean the tank
in good time to prevent the solids from hardening in the tank. Circulate
the contents of the tank when they are not being used by swirling the
tank in circular movements.
Dentsply Sirona
Operating Instructions inLab
64 78 759 D3608
D3608.201.01.07.02 10.2017