Technical Data; Dentsply Sirona - DENTSPLY inLab MC X5 Operating Instructions Manual

2 General information on the device
2.5 Technical data
18
2.5

Technical data

Type designation
Rated line voltage
Rated power frequency
Nominal current
Nominal power output
Permissible line voltage
fluctuations
Compressed air connection
Compressed air consumption
Type of protection against electric
shock
Degree of protection against
ingress of water
Overvoltage category
Shock stress
Ambient conditions
Temperature range
Humidity range
Operating mode
Dimensions W x H x D
in mm
in inches
Approx. weight

Dentsply Sirona

Operating Instructions inLab MC X5
inLab MC X5
AC 100V ... 240V
50/60 Hz
2.0A
200VA
±10% of nominal voltage
At least 7.0bar / 0.7MPa / 102psi
upstream of filter regulator input
Filter regulator setting
6.5 - 7.0bar
At least 50 l/min (1.8cfm)
Briefly up to 100 l/min (3.6cfm)
Recommended for dry operations:
At least 80 l/min (2.8cfm)
Class I device
Usual device (without protection
against ingress of water), IP 20
II
1J (IK06) on door glass,
5J (IK08) on remaining device
The impact strength on the door
glass was tested with a pendulum
blow test from a vertical falling
height of 400 mm.
For indoor use
Pollution degree 2
Air pressure: 700 hPa – 1060 hPa
Operating height: ≤ 3000 m above
sea level
+5°C up to +40°C
(+41°F - 104°F)
80% rel. up to 31°C (88°F)
decreasing to
50% rel. up to 40°C (104°F)
Continuous operation
629 x 795 x 575
24 ¾ x 31 ⅜ x 22 ⅝
87kg (191.8lbs)
64 78 759 D3608
D3608.201.01.07.02 10.2017