Filling The Coolant Tank - DENTSPLY inLab MC X5 Operating Instructions Manual

5 Commissioning
5.2 Putting the unit into operation
A
42
8. Connect the suction hose of the mandrel suction A in the processing
chamber.
9. Mount the suction bellows on the mandrel. To do this, first allow the
rear part of the bellows to engage into the groove of the mandrel.
Then pull the suction bellows over the mandrel by holding at the two
front rubber handles so that the bellows are engaged on all sides.
5.2.5 Filling the coolant tank (for material classes PMMA/wax,
composite and grinding materials)
IMPORTANT
Note material class
This section applies for the use of the coolant tank when processing the
material class PMMA/wax (material class index red), composite
(material class index blue) and grinding materials (material class index
white).
When processing materials from material classes sintering metal (gray)
and metal (green), observe the specific instructions for filling the coolant
tank in then specific sections on processing such materials.
✔
The unit is switched on.
✔
No machining process is running.
NOTICE
Risk of damage to the hoses!
Pulling at the inlet and outlet hoses may damage them.
➢ Always draw off the hoses at the pipe piece.
Dentsply Sirona
Operating Instructions inLab MC X5
64 78 759 D3608
D3608.201.01.07.02 10.2017