Putting The Unit Into Operation; Connecting The Unit To The Power Supply; Checking The Compressed Air; Functional Elements - DENTSPLY inLab MC X5 Operating Instructions Manual

Dentsply Sirona

Operating Instructions inLab MC X5
64 78 759 D3608
D3608.201.01.07.02 10.2017
5.2

Putting the unit into operation

5.2.1

Connecting the unit to the power supply

NOTICE
Grounded power outlet
The unit must be connected to a grounded power outlet.
➢ Connect the unit to the power supply using the supplied power cable.
5.2.2

Checking the compressed air

1. Check whether 7bar / 102psi of compressed air is displayed on the
filter regulator display.
2. If this is not the case check your compressed air system and/or
contact your responsible compressed air installer.
5.2.3

Functional elements

5.2.3.1

Button assignment

These operating instructions describe how to operate the unit by
executing and confirming commands via your PC. You can also directly
actuate the commands such as
buttons on the device.
For the commands, refer to the table below.
Button assignment
Push button
A
B
C
5 Commissioning
5.2 Putting the unit into operation
"Start" "Stop" "Ok"
, or by pressing the
Function
ON/OFF button
Start/ stop/ resume process
Open door
A
B
C
39