DENTSPLY inLab MC X5 Operating Instructions Manual page 96

7 Maintenance and cleaning
7.9 Procedure when processing Medentika-PreFace® abutment semi-finished products made of titanium
96
6. To fasten the PreFace
the respective fixation. Make sure that the thread does not tilt during
this step. Now slightly tighten the screws with the help of the torque
wrench for the tool holder in an alternating manner. Tighten the
screws finally using the torque wrench at the preset torque. The
required torque is reached if a clicking/ popping sound is heard when
tightening the screws. Use only the torque wrench supplied with the
®
PreFace holder from Sirona for fixing the workpiece.
7. Close the door of the machine after inserting and fixing the PreFace
holder, and follow the instructions of the software.
Operating Instructions inLab
®
holder, place the three screws (A) back into
D3608.201.01.07.02 10.2017
Dentsply Sirona
®
64 78 759 D3608