Complete A Coolant Change - DENTSPLY inLab MC X5 Operating Instructions Manual

Dentsply Sirona
Operating Instructions inLab MC X5
B
C
D
64 78 759 D3608
D3608.201.01.07.02 10.2017
7.7.3.2

Complete a coolant change

CAUTION
Risk of injury
There is risk of injury through sharp-edged restorations as well as sharp-
edged material residues in the tank.
➢ Pay attention to the sharp-edged restorations / material residues
after processing, during cleaning and coolant changes.
NOTICE
Checking whether the available connections are leakproof
Check the connections after each coolant change for any leaking fluids
under the unit or in the area.
To change the coolant, proceed as follows:
✔
The unit is switched on.
✔
No machining process is running.
NOTICE
Risk of damage to the hoses!
Pulling at the inlet and outlet hoses may damage them.
➢ Always draw off the hoses at the pipe piece.
1. Draw off the machine-sided tank inlet hose (A) with the large diameter
as well as the thin coolant supply hose (B) from the tank. Pay
attention to leaking residual liquid and catch it with a separate
collecting container, if necessary.
A
7 Maintenance and cleaning
7.7 Coolant system
83