Infors HT Multitron Pro Operating Manual page 56

Multitron Pro - Incubation Shaker
Setup and function
Visual alarm
Acoustic alarm
Visual error message
Acoustic error message
Page 56 of 185
An alarm is triggered when a parameter does not reach the
setpoint value within defined time.
The alarm is automatically cancelled when the parameter reaches
the setpoint value.
There are three ways of issuing an alarm:
visually
acoustically
analog signal
Value below setpoint: Low
Value above setpoint: High
Restart after power failure
PIEP – PIEP – PAUSE – PIEP – PIEP
An error message is triggered when the incubation shaker ha a
fault.
This is the case when a component is defect or communication
between sensor and control is interrupted.
The displays show various error messages. Please refer to chapter
Interferences.
Message ERROR lights and warning symbol blinks.
PIEP – PAUSE – PIEP
2013-02-19