Infors HT Multitron Pro Operating Manual page 146

Multitron Pro - Incubation Shaker
Maintenance
Side-mounted cooling system
Procedure
Fig. 101
Top-mounted cooling system
Procedure
Fig. 102
Coolant
Page 146 of 185
1. Remove the screws holding the grating.
2. Lift off the grating.
3. Clean the fins with a vacuum cleaner.
4. Reattach the grating with the two screws.
1. Visually inspect the heat exchanger of the top-mounted
cooling system for dust.
2. If there is a lot of dust, contact the manufacturer's service
center.
Maintenance of the coolant system must be carried out by the
manufacturer's service center.
Annual check of the coolant level.
Replacement of the coolant every 3 years.
2013-02-19