Using The «Sticky Stuff» Adhesive Matting - Infors HT Multitron Pro Operating Manual

7.14 Using the «Sticky Stuff» adhesive matting
Loading the «Sticky Stuff» adhesive matting
Unloading the «Sticky Stuff» adhesive matting
Procedure
2013-02-19
CAUTION!
Risk of material damage due to the detachment
of cultivation flasks from the „Sticky Stuff"
adhesive matting due to condensation inside
the incubation chamber.
The cultivation flasks may become unstuck from
the adhesive matting» if there is condensation
inside the incubation chamber.
Therefore:
– Ensure that condensation cannot form during
humidification.
The «Sticky Stuff» adhesive matting is used underneath cultivation
flasks with large, flat bottoms.
Only undamaged, unscratched cultivation flasks may be used on
the adhesive matting».
To achieve maximum adhesion to the «Sticky Stuff» adhesive
matting, the flasks and matting must be completely undamaged,
clean, dry and oil-free.
After placing the flasks on the matting», tilt each flask gently to
check that they are adhering firmly.
1. Tilt the neck of the cultivation flask gently to one side.
2. Wait until the flask has become detached from the matting».
Multitron Pro - Incubation Shaker
Operation
Page 129 of 185