Starting A Work Cycle - Infors HT Multitron Pro Operating Manual

7.6 Starting a work cycle

Procedure
2013-02-19
5. Press ON/OFF key to switch on the parameter.
6. Press REMOTE key to finish remote access.
EXTERN does not light on any unit.
The parameters have to be set and activated before a work cycle
can be started.
The respectively selected parameters light up on the operating
panel.
NOTICE!
Ensure that the flasks shaken are fixed securely.
Watch flask from the start of the shaking operation
until setpoint is reached.
1. Press option key to select parameter.
E.g.: Parameter temperature is selected.
Temperature sign and unit °C light up.
If parameter is ON, upper display shows the current value, e.g.
30,0 °C.
If parameter is OFF, upper display shows OFF and setpoint
alternating.
NOTICE!
The setpoint values of the parameter remain stored
for approx. 1 month after the unit has been
switched off.
Multitron Pro - Incubation Shaker
Operation
Page 117 of 185