Cleaning Mode - Dräger caleo Instructions For Use Manual

*

Cleaning mode

– Cleaning mode is only available if Caleo
humidity control.
– Cleaning mode can only be used if there is not a patient in
®
the Caleo .
– Only use cleaning mode with an ambient humidity
of >10 % relative humidity.
– Close the terminal on the connection set before starting
cleaning mode.
– Cleaning mode takes approx. 60 minutes.
– The water heater is heated up during cleaning mode. The
residue water evaporates. The water heater then cools
down.
– During cleaning mode Caleo
relative humidity. The value will not be displayed. If the
relative humidity falls below 10 % the "Humidity sensor
faulty" alarm will be triggered. Cleaning mode cannot be
ended in the correct manner. In order to maintain a relative
humidity of >10 %, the front and side flaps and the hood
should be open during cleaning mode.
– During or after cleaning mode, condensation could form
under the aggregate housing of the Caleo
1 Open menu = press the »menu« button.
Select "Cleaning Mode" from the displayed menu.
2 Select item = turn the rotary knob.
2 Confirm (activate) item = press the rotary knob.
* optional equipment feature
®
is equipped with
®
continues to measure the
®
!
D
D
1
1
Operation
Selecting menus
2
2
77