Dräger caleo Instructions For Use Manual page 98

Disinfecting/Cleaning/Sterilising
Stripping down
®
Place Caleo horizontal (see page 27).
l
Switch on cleaning mode
l
After cleaning mode* has completed or if humidity control
is not provided:
Switch off the incubator and disconnect from mains.
l
Remove any auxiliary equipment installed (for care
l
instructions see the specific Instructions for Use of the
equipment concerned).
Risk of burns on contact with the heater.
®
Allow Caleo to cool down before stripping down further.
Removing the double wall
1 Pull the plunger up as far as it will go.
The red shaft of the plunger will then be visible.
2 Grip the double wall with both hands and lift it off.
Place the double wall on a soft, non-scratch surface.
l
Remove the continuous seal from around the double wall.
l
3 Force the bore sleeve apart
and
4 remove the plunger.
* Only available in combination with humidity control.
98
*
(see page 77).
1
2
3
4
2