Dräger caleo Instructions For Use Manual page 2

How to use the Instructions for Use
How to use the Instructions for Use
The headline...
specifies the subject of the main chapter
to help you find your way around rapidly.
The page...
contains instructions for use of the unit
in a combination of text and illustrations. The information is
translated directly into practical actions showing the user
how to use the unit.
The left-hand column...
contains text
explaining the unit and guiding the user clearly to its uses
through concise instructions in ergonomic sequence.
Dots refer to actions,
l
1 Numbers refer to the illustration next to the text and to the
sequence of actions in the case of operations consisting of
several steps.
The right-hand column...
contains illustrations
as a reference to the text and to guide the user in handling the
unit itself. The elements mentioned in the text are highlighted,
and unnecessary details are omitted. The user is guided by
screens confirming the various steps required for each action.
2
Preparation
Before using for the first time
Mounting accessories
Preparation
Before using for the first time
Check that all packaging materials have been completely
removed (see packing slip in the pack).
Check that the mains power supply voltage matches the
voltage rating specified on the nameplate (see page 138).
Check that the altitude above sea level is correctly set
(see page 82).
Mounting accessories
When fitting accessories, please note:
Any equipment mounted on the accessories must not
collide with the unit when adjusting the tilt angle and height
®
of Caleo .
Any equipment mounted on accessories on the handle
side must not move with the main unit during height
®
adjustment of Caleo (page 121).
Screw on
pole 38 mm/600 (2M 50 691) or alternatively
pole 38 mm/310 (2M 50 688) or alternatively
pole 25 mm/600 (2M 50 689).
Remove the cover plate from the base frame.
Screw the pole fully into the base frame and tighten firmly.
Check that it is securely held in position.
Observe the maximum loads.
Danger of overturning the unit!
Pole 38 mm/600 10 kg
Pole 38 mm/310 10 kg
Pole 25 mm/600 3 kg
Distance between the loads and the pole: max. 150 mm.
Moving the control unit to the opposite side
for pole, 38 mm
1 Remove the control unit = loosen the clamping screw.
2 Remove the holder = loosen the clamping screw.
On delivery, the control unit is fixed to the 38 mm/310 tube.
This tube is secured by a screwed fixing for transport. If
required, the tube can be released (recommendation: ask for
assistance from specialised technical personnel):
3 Remove both caps from the tube. Insert a screwdriver in the
holes and release the tube.
To fit the control unit to the adjacent side:
Push the holder over the tube and set it to the desired
working height.
2 Fix the holder in position = tighten the clamping screw.
Set the control unit to the desired working height.
1 Secure the control unit to the holder = tighten the clamping
screw.
Make sure that the swivel zone remains clear.
14
1
2
3